Thermo Scientific 43i, Инструкция по эксплуатации

Страница: 19 / 312

Thermo Fisher Scientific Model 43 i Trace Level-Enhanced Instruction Manual xix
Figures
Figure 1–1. Model 43i Trace Level-Enhanced Flow Schematic......................... 1-3
Figure 2–1. Remove the Packing Material ......................................................... 2-2
Figure 2–2. Removing the Shipping Screws ...................................................... 2-2
Figure 2–3. Rear Panel........................................................................................ 2-4
Figure 2–4. Atmospheric Dump Bypass Plumbing ............................................. 2-5
Figure 2–5. I/O Terminal Board Views ............................................................... 2-6
Figure 2–6. D/O Terminal Board Views.............................................................. 2-7
Figure 2–7. 25-Pin Terminal Board Views.......................................................... 2-8
Figure 3–1. Front Panel Display.......................................................................... 3-2
Figure 3–2. Front Panel Pushbuttons.................................................................. 3-3
Figure 3–3. Flowchart of Menu-Driven Software .............................................. 3-5
Figure 3–4. Pinout of Rear Panel Connector in Single Range Mode ................. 3-8
Figure 3–5. Pinout of Rear Panel Connector in Dual Range Mode.................... 3-9
Figure 3–6. Analog Output in Autorange Mode............................................... 3-11
Figure 3–7. Pin-Out of Rear Panel Connector in Auto-Range Mode ............... 3-11
Figure 4–1. Cylinder Gas Dilution System.......................................................... 4-3
Figure 4–2. Permeation Tube System ................................................................ 4-4
Figure 5–1. Inspecting and Replacing the Capillary........................................... 5-3
Figure 5–1. Inspecting and Cleaning the Fan..................................................... 5-5
Figure 5–2. Rebuilding the Pump........................................................................ 5-7
Figure 6–1. Board-Level Connection Diagram - Common Electronics ............. 6-10
Figure 6–2. Board-Level Connection Diagram – Measurement System ......... 6-11
Figure 7–1. Properly Grounded Antistatic Wrist Strap ...................................... 7-2
Figure 7–2. Model 43i Trace Level-Enhanced Component Layout .................... 7-6
Figure 7–4. Removing the Measurement Bench and Lowering the Partition
Panel ..................................................................................................................... 7-7
Figure 7–5. Replacing the Pump......................................................................... 7-9
Figure 7–6. Replacing the Fan .......................................................................... 7-10
Figure 7–7. Replacing the Optical Bench ......................................................... 7-12
Figure 7–8. Replacing the Flash Lamp and Flash Trigger Assembly ............... 7-13
Figure 7–9. Replacing the Flash Intensity Assembly ....................................... 7-16
Figure 7–10. Replacing the PMT ...................................................................... 7-17
Figure 7–11. Replacing the PMT High Voltage Power Supply (HVPS) ............ 7-18
Figure 7–12. Replacing the DC Power Supply.................................................. 7-20
Figure 7–13. Rear Panel Analog Input and Output Pins................................... 7-22
Figure 7–14. Replacing the Pressure Transducer Assembly............................ 7-27