125
Misc Menu Operations
Chapt
er 8 Color
B
ac
kg
roun
ds
, Cop
y and
S
w
ap
, a
nd Ot
he
r
S
et
tings
The status area shows lists for the copy/swap source on
the left, and the copy/swap destination on the right.
2
In the <Data Select> group, select either of the
following.
Wipe:
Applies operations to wipes in the transition
control block.
Key Wipe:
Applies operations to wipes in the
independent key transition control block.
3
Select the copy/swap source data and copy/swap
destination data
4
Press [Copy] to copy, or press [Swap] to swap.
To undo a copy or swap
Press [Undo] to return to the state before the copy or swap
was carried out.
Copying using button operations
You can copy keyer data using the key delegation buttons
in the transition control block.
Basic button operation
The basic button operation is to hold down the copy source
button, then press the destination button.
You can undo the last operation using [Undo] in the menu
To copy from M/E-1 key 1 to PGM/PST key 2
While holding down the [KEY1] transition control block
button in the M/E-1 bank, press the [DSK2] transition
control block button in the PGM/PST bank.
Misc Menu Operations
In the Misc menu, you can carry out the following
operations.
• Enabling or disabling control from an external device.
• Enabling or disabling side flags for each background bus
of each of the switcher banks.
For details about the side flag function,
• Switching the safe title function on or off for each
switcher output.
• Displaying the transition rate, independent key transition
rate, and fade-to-black transition rate for each of the
switcher banks, and changing the settings.
Port Settings for Control from an
External Device
Enabling or disabling control from an
external device
1
Open the Misc >Enable >Port Enable menu (3211).
The status area shows the setting status of each of the
following ports.
• Switcher Remote S1 to Remote S2 ports (RS-422A,
D-sub 9-pin)
• Switcher GPI port (parallel, 25-pin)
2
In the <Switcher> group, press on the name of the port
for which you want to disable control from an external
device, turning it off.
To re-enable control for the port, press on its name
again.
For AUX bus operations from the Remote S1 to
Remote S2 ports of the switcher, the setting (Enable/
Disable/Manual) in the Setup menu takes precedence.
The settings made in the Port Enable menu only apply
when the setting is set to “Manual.”
For details,
“Enabling or Disabling AUX Bus
Safe Title Settings
Turning the safe title function on/off
1
Open the Misc >Safe Title menu (3221).
2
Select the signal to set.
You can select from Outputs 1 to 12.
• Outputs 13 to 32 cannot be set.
• It is not possible to change the setting for the output
for which the safe title is set off in a Setup menu.
• The safe title function cannot be used for output
signals for which through mode is set to Enable in a
Setup menu.
For details,
“Signal Output Settings” (p. 246)
.
3
Press [Safe Title], turning it on or off.
Notes
Notes
