227
Setting Button Assignments
Chapt
er 17
Cont
ro
l P
anel Se
tup
5
Press [Source Table Set] to confirm the selection.
6
Repeat steps
2
to
5
as required.
Setting the Source Table
1
Open the Engineering Setup >Panel >Router Remote
>RTR Mode Setting >Table Assign menu (7323.3).
2
In the <Source Table Select> group, select the source
table you want to manipulate.
3
Select a source selection button and the source you
want to assign.
4
Press [Source Set] to confirm the selection.
Assigning Levels to a Level
Selection Button
To assign levels to the [LEVEL1] to [LEVEL4] buttons in
the auxiliary bus control block, use the following
procedure.
1
Open the Engineering Setup >Panel >Router Remote
>RTR Mode Setting >Level Button Assign menu
(7323.4).
2
In the <Level Button Select> group, select the button
you want to set.
3
In the <Level Assign> group, press the levels you want
to assign to the button, turning them on.
You can select multiple levels. You can also make a
selection that overlaps that of another button.
Selecting a Destination Selection
Button for a Snapshot
1
In the Engineering Setup >Panel >Router Remote
>RTR Mode Setting menu (7323.1), select the
destination selection button to set.
2
Press [SS Enable], turning it on or off.
On:
When a snapshot applying to the router is
recalled, the recall also applies to the selected
destination selection button.
Off:
When a snapshot applying to the router is
recalled, the recall does not apply to the selected
destination selection button.
When a destination selection button is set to Inhibit,
then even if SS Enable is on, the snapshot for that
destination is not recalled.
Setting Button
Assignments
You can assign user preference buttons that can be
accessed via macros or GPI ([PREFS 1] to [PREFS 16])
and the cross-point control block buttons.
This assigns recalling frequently used menus (menu
shortcuts), enabling/disabling functions (recalling utility
commands) and recalling shotbox registers or macro
registers.
User preference buttons are virtual buttons that can be
accessed via a macro or GPI. They are not physical buttons
on the control panel.
Assigning Functions to User
Preference Buttons
1
In the Engineering Setup >Panel >Prefs/Utility menu
(7324), select the button to be assigned.
2
In the <Action> group, select the function to be
assigned.
Menu Shortcut:
Disabled, even if selected.
Utility Command:
Assigns a function enable/disable
or similar operation (utility command).
Macro Recall:
Assigns a macro register recall.
Shotbox Recall:
Assigns a shotbox register recall.
3
Depending on the selection in step
2
, make the
following settings.
If Utility Command is selected:
Select a command
on the right side of the status area.
If Macro Recall is selected:
Select the macro register
you want to assign.
No.
Parameter
Adjustment
3
Source
Table
Source table selection
Notes
Notes
