Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
792
Managing IPv4 Addresses
Section 5.38.3
Managing IPv4 Addresses
The following sections describe how to configure and manage IPv4 addresses:
•
Section 5.38.3.1, “Viewing a List of IPv4 Addresses”
•
Section 5.38.3.2, “Adding an IPv4 Address”
•
Section 5.38.3.3, “Deleting an IPv4 Address”
Section 5.38.3.1
Viewing a List of IPv4 Addresses
To view a list of IPv4 address for a routable interface, navigate to
ip
»
{interface}
»
ipv4
, where
{interface}
is the
name of the routable interface. If addresses have been configured, the
Addresses
table appears.
Figure 912: Addresses Table
If no addresses have been configured, add addresses as needed. For more information, refer to
Section 5.38.3.2
Adding an IPv4 Address
To add an IPv4 address to a routable interface, do the following:
1. Change the mode to
Edit Private
or
Edit Exclusive
.
2. Navigate to
ip
»
{interface}
»
ipv4
, where
{interface}
is the name of the routable interface.
3. Click
<Add address>
. The
Key Settings
form appears.
Содержание RUGGEDCOM RX1510
