Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
546
Viewing a List of Interfaces for IPv4 Static Routes
1
2
Figure 634: Static Route Using Interface Form
1.
Interface Name Box
2.
Distance Box
4. Configure the following parameter(s) as required:
Parameter
Description
Interface Name
The interface for the static route.
Distance (optional)
The distance for the static route.
5. Click
Commit
to save the changes or click
Revert All
to abort. A confirmation dialog box appears. Click
OK
to proceed.
6. Click
Exit Transaction
or continue making changes.
Section 5.22.7.2
Viewing a List of Interfaces for IPv4 Static Routes
To view a list of interfaces assigned to an IPv4 static route, navigate to
routing
»
static
»
ipv4
»
{subnet}
»
dev
,
where
subnet
is the subnet (network/prefix) of the static route. If interfaces have been configured, the
Static
Route Using Interface
table appears.
Figure 635: Static Route Using Interface Table
If no interfaces have been configured, add interfaces as needed. For more information, refer to
“Adding an Interface for an IPv4 Static Route”
.
Section 5.22.7.3
Adding an Interface for an IPv4 Static Route
To add an interface for an IPv4 static route, do the following:
Содержание RUGGEDCOM RX1510
