Siemens RUGGEDCOM RX1510, Руководство пользователя

Страница: 497 / 856

RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Deleting a Neighbor 465
Parameter Description
in Apply route map to incoming routes.
out Apply route map to outbound routes.
6. On the Neighbor form, configure the following parameter(s) as required:
Parameter Description
Neighbor Autonomous System ID A BGP neighbor.
ebgp-multihop The maximum hop count. This allows EBGP neighbors not on directly connected
networks.
Maximum Prefix The maximum prefix number accepted from this peer.
next-hop-self Disables the next hop calculation for this neighbor.
password Password.
update-source Source IP address of routing updates.
disable-connected-check Disables connection verification when establishing an eBGP peering session with a
single-hop peer that uses a loopback interface.
soft-reconfiguration Per neighbor soft reconfiguration.
weight The default weight for routes from this neighbor.
7. Click
Commit
to save the changes or click
Revert All
to abort. A confirmation dialog box appears. Click
OK
to proceed.
8. Click Exit Transaction or continue making changes.
Section 5.19.7.3
Deleting a Neighbor
To delete a neighbor from a BGP network, do the following:
1. Change the mode to
Edit Private or Edit Exclusive .
2. Navigate to routing
»
dynamic
»
bgp
»
neighbor . The Neighbor table appears.
1
2
3
Figure 524: Neighbor Table
1. Add Button 2. Edit Button 3. Delete Button
3. Click
Delete
next to the chosen neighbor.