Siemens RUGGEDCOM RX1510, Руководство пользователя

Страница: 552 / 856

Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
520 Managing Route Maps
2 3 1
Figure 597: OSPF Area Table
1. Add Button 2. Edit Button 3. Delete Button
3. Click Delete next to the chosen area.
4. Click
Commit
to save the changes or click
Revert All
to abort. A confirmation dialog box appears. Click
OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.21.6
Managing Route Maps
Route maps are sequential statements used to filter routes that meet the defined criteria. If a route meets
the criteria of the applied route map, it can either be excluded from the routing table or prevented from being
redistributed. In ROX II, route maps are configured to filter routes based on their metric value, which defines the
cost of the route. Once a match is found, the assigned action is taken.
Each route map requires a sequence number (e.g. 10, 20, 30, etc.), which allows for multiple route maps to be
run in sequence until a match is found. It is recommended to create sequence numbers in intervals of 10, in case
a new route map is required later between two existing route maps.
The following sections describe how to configure and manage route maps for OSPF:
•
Section 5.21.6.1, “Viewing a List of Route Map Filters”
• Section 5.21.6.2, “Viewing a List of Route Map Filter Entries”
• Section 5.21.6.3, “Adding a Route Map Filter”
• Section 5.21.6.4, “Adding a Route Map Filter Entry”
• Section 5.21.6.5, “Deleting a Routing Map Filter”
• Section 5.21.6.6, “Deleting a Routing Map Filter Entry”
• Section 5.21.6.7, “Configuring Match Rules”
Section 5.21.6.1
Viewing a List of Route Map Filters
To view a list of route map filters for either dynamic OSPF routes, navigate to
routing
»
dynamic
»
ospf
»
filter
»
route-map
. If filters have been configured, the
Route Map
table appears.