RUGGEDCOM ROX II
User Guide
Chapter 3
Device Management
Viewing a List of Ethernet Trunk Ports
139
•
Section 3.22.4.3, “Deleting an Ethernet Trunk Port”
Section 3.22.4.1
Viewing a List of Ethernet Trunk Ports
To view a list of Ethernet trunk ports, navigate to
interface
»
trunks
»
{id}
»
trunk-ports
, where
{id}
is the ID
given to the interface. If trunk ports have been configured, the
Trunk Ports
table appears.
Figure 142: Trunk Ports Table
If no Ethernet trunk ports have been configured, add ports as needed. For more information, refer to
Section 3.22.4.2, “Adding an Ethernet Trunk Port”
Section 3.22.4.2
Adding an Ethernet Trunk Port
To add an Ethernet trunk port, do the following:
1. Change the mode to
Edit Private
or
Edit Exclusive
.
2. Navigate to
interface
»
trunks
»
{id}
»
trunk-ports
, where
{id}
is the ID given to the interface.
3. Click
<Add trunk-ports>
. The
Key Settings
form appears.
1
2
Figure 143: Key Settings Form
1.
Trunk Slot List
2.
Add Button
4. Configure the following parameter(s) as required:
NOTE
Routable Ethernet ports cannot be configured as trunk ports.
Содержание RUGGEDCOM RX1510
