Riftek RF627 Series, Руководство пользователя

Страница: 38 / 130

38
Laser Scanners
RF627, RF627Smart [Revision 2.1.2] 20.09.2021
Parameters:
Parameter Factory value Description
Type Unidirectional Counter type:

Unidirectional – Unidirectional counter (non-reversible).

Bidirectional – Bidirectional counter (reversible).
Reset time OFF Resetting the counter after a specified time in the absence of
synchronization events.
Time out, us 4294967
(maximum value)
Time interval for reset in the absence of synchronization events.
Max counter value 4294967295
(maximum value)
The maximum value of the counter. The counter will be reset when
exceeding this value.
20.4.3. Examples
Examples of trigger settings:
# Event source How it works Options How to install
1 Internal generator. Profiles are transmitted continuously
at the set frame rate (FPS). Each
measurement starts with an internal
generator.
·
Set the required frame
rate.
·
Select the Internal
source.
2 Software request. Each measurement starts with
receiving the software request.
·
Select the Software
source.
·
See the Developer
Guide.
3 External trigger. Triggering
a single measurement.
Each measurement starts with
receiving the trigger signal at input
#1, taking into account the set
parameters.
·
Triggering the
measurement
on the rise of the
input pulse.
·
Triggering the
measurement
on the fall of the
pulse.
·
Triggering the
measurement
on the rise and
fall of the pulse.
·
Delay.
·
Divider.
·
Connect the source to
input #1 and enable the
output.
·
In the Inputs section,
select the required
mode.
·
If necessary, set the
Delay parameter.
·
If necessary, set the
Divider parameter.
4 Encoder, one phase. Same as #3. Same as #3. Same as #3.
5
Encoder, one phase and
"0" mark. Same as #3.
The measurement counter is reset
on phase Z. Same as #3.
·
Same as #3.
·
Connect phase Z to
input #3.
·
Enable input #3 and
select the mode.
6 Encoder, two phases. Each measurement starts with
receiving the quadrature encoder
signals (multiplication by 4) at inputs
#1 and #2, taking into account the
set division ratio.
The direction of movement is
controlled (or is not controlled), the
direction indication is transmitted (or
is not transmitted) in the data
packet.
·
Divider.
·
Reversible /
non-reversible
counting.
·
Connect phase A to
input #1, enable the
input.
·
Connect phase B to
input #2, enable the
input.
·
Select the operating
mode (
Mode ) for both
inputs: Rise or Fall.
·
If necessary, set the
Divider parameter.
·
Select the Counter type :
Bidirectional or
Unidirectional.