Riftek RF627 Series, Руководство пользователя

Страница: 70 / 130

70
Laser Scanners
RF627, RF627Smart [Revision 2.1.2] 20.09.2021
rise edge fall edge
first, constr last, constr
"Index" 0...256 The segment index used in the "Mode" = "by index".
"Min len", mm 0,01...1000 The minimum segment length used in modes
"Mode" = "first, constr." and “Mode” = “last, constr.”.
"Max len", mm 0,01...1000 The maximum segment length used in modes
"Mode" = "first, constr." and “Mode” = “last, constr.”.
"Angle", deg -90...90 The angle of inclination of the segment relative to the
horizontal axis. It is used in modes "Mode" = "first,
constr." and “Mode” = “last, constr.”
"Angle tolerance",
deg 0...89 The tolerance (in both directions) of the angle of
inclination of the segment relative to the horizontal
axis. It is used in modes "Mode" = "first, constr."
and “Mode” = “last, constr.”
Outputs: “seg” SDT_SEGMENT The segment corresponding to the block
parameters.
“line approximation” - line approximation of profile points (in two areas).
original profile without
approximation
approximation of lower fragments approximation of upper fragments
Outputs: “line” SDT_LINE The line that approximates the points located in
areas.
“calculate filling” - calculating the total area of the profile deviation from the base input line.