Riftek RF627 Series, Руководство пользователя

Страница: 39 / 130

RF627, RF627Smart [Revision 2.1.2] 20.09.2021
Laser Scanners
39
# Event source How it works Options How to install
7 Encoder, two phases and
"0" mark. Same as #6.
The measurement counter is reset
on phase Z. Same as #6.
·
Same as #6.
·
Connect phase Z to
input #3.
·
Enable input #3 and
select the operating
mode (
Mode ).
8
Step/Dir signal
(Step/Direction). Each measurement starts with
receiving the Step signal at input #1,
taking into account the set division
ratio.
The direction indication (Dir) is
transmitted in the data packet.
·
Triggering the
measurement
on the rise of the
pulse.
·
Triggering the
measurement
on the fall of the
pulse.
·
Divider.
·
Connect the Step signal
to input #1.
·
Connect the Dir signal
to input #2
·
If necessary, set the
Divider parameter.
9 External trigger. Starting a
series of measurements
with the internal generator. The series of measurements with
the set frame rate (FPS) starts with
receiving a signal at input # 1.
The series of measurements stops
when the signal level changes.
·
Triggering the
series of
measurements
at a high level of
the pulse.
·
Triggering the
series of
measurements
at a low level of
the pulse.
·
Connect the source to
input #1
·
Set the required value:
High Level or Low
Level .
20.5. Setting the outputs
The Outputs section contains the parameters of the outputs.
Parameters:
Parameter Factory value Description
Enable OFF Enable / disable the output.
Mode Exposure start Output signal generation mode:

Exposure start – Formation of the output pulse with a duration of
1 s upon the event that triggers the measurement cycle.

Exposure time – Formation of the output signal that coincides
with the
Exposure time signal on the timing diagram.

In1 repeater – Duplication of the signal from input #1 to the
output.

In2 repeater – Duplication of the signal from input #2 to the
output.

In3 repeater – Duplication of the signal from input #3 to the
output.
Note: The delay of the output signal in relation to the duplicated
signals is about 50 ns.