NetApp AFF A700, Системная документация

Страница: 433 / 1672

Step 1: Remove the controller module
To access components inside the controller module, you must remove the controller
module from the chassis.
You can use the following images or the written steps to remove the controller module from the chassis.
The following image shows removing the cables and cable management arms from the impaired controller
module:
The following image shows removing the impaired controller module from the chassis:
1. If you are not already grounded, properly ground yourself.
2. Unplug the controller module power supply from the power source.
3. Loosen the hook and loop strap binding the cables to the cable management device, and then unplug the
system cables and SFPs (if needed) from the controller module, keeping track of where the cables were
connected.
Leave the cables in the cable management device so that when you reinstall the cable management
device, the cables are organized.
4. Remove and set aside the cable management devices from the left and right sides of the controller module.
5. Remove the controller module from the chassis:
a. Insert your forefinger into the latching mechanism on either side of the controller module.
b. Press down on the orange tab on top of the latching mechanism until it clears the latching pin on the
chassis.
The latching mechanism hook should be nearly vertical and should be clear of the chassis pin.
430