NEC ElectraElite IPK, Руководство по программированию

Страница: 326 / 803

Electra Elite IPK Document Revision 4
Programming Manual 2 - 249
___________________________________________________________________________________
___________________________________________________________________________________
1-8-43 Enhanced 911 Trunk Assignment
General Description
Use this feature to define an available loop-start trunk as a CAMA or an ISDN PRI
trunk. When a user dials 911, the system seizes the E911 trunk and sends additional
digits (CESID) to enable the PSAP center to recognize the callback telephone
number. The E911 trunk must be connected to a COI(4)/(8)-U( ), COID(4)/(8)-U( ),
COIB(4)-U( ), or COIB(8)-U( ) Loop Start port and assigned to the system. When the
system is installed at a K-CCIS Remote Office, the Trunk Group or Route Advance
Block that connects to the Main Office is assigned.
System Software R2000 or higher is required to select a Trunk Group or Route
Advance Block.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK8
The shaded
selection is the
default.
CO/PBX
No.
TG/RAB
No.
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 +
DC
to access the Memory Block.
3 Press Line Key to select CO/PBX No. or TG/RAB No.
Use the following to enter data:
K
~
I
to enter numeric data
J
to move cursor left
L
to move the cursor right
H
to clear data
Setting Data: Not Specified (default)
CO No. 01~64
101~132 Trunk Group 01~32
201~232 Route Advance Block 01~32
System Software R1700 and lower only allows CO No. 01~64 to be entered.
4 Press
G
to write the data. The next Memory Block is displayed.
5 Program next Memory Block or press
E
to go back on-line.
System Mode
1
Submode
8
Data No.
43
PC Programming
¦
+AE
Data
No.
4 3 : 9 1 1 T R U N K
T I M E D I S P L A Y
Setting
Data Title