NEC ElectraElite IPK, Руководство по программированию

Страница: 468 / 803

Electra Elite IPK Document Revision 4
Programming Manual 2 - 391
___________________________________________________________________________________
___________________________________________________________________________________
1-16-06 Port Based Priority Selection
General Description
Use this memory block to specify how frames, reaching the ingress port without VLAN
tags are marked for queuing internally in the HUB(8). The HUB(8) has two queues:
High Priority and Low Priority. When the frame reaches the egress port, settings for
Memory Blocks 1-16-08 (for High Priority frames) and 1-16-09 (for Low Priority
frames) for the egress port are used to convert the low or high priority queue to a
VLAN tag priority (0~7). Set to NO (default), this Memory block does not mark frames
for either queue; Memory Block 1-16-07 then determines the priority queue for where
the frame is sent.
R1500 or higher is required.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default.
NO
(Not
Assigned)
LO
Low
HI
High
Programming Procedures
1 Go off-line.
2 Press LK1 + LK16 +
JJKF
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press
G
to write the data.
5 Repeat steps 3 and 4 for each HUB(8)-U( ) ETU.
6 Press
E
to go back on-line.
System Mode
1
Submode
16
Data No.
06
PC Programming
¦
+AB
0 6 : 1 - 1 Q o S N O
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
PORT
1~8
HUB
1~3