Mitsubishi Electric MELSERVO-J4 series, Инструкция по эксплуатации

Страница: 568 / 646

566
APPX
Appendix 1 When using the servo amplifier with the DC power supply input
Power supply capacity
The power supply capacity is the same as that for the AC power supply input.

Page 315 Power supply capacity and generated loss
Selection example of wires
Selection conditions of wire size are as follows.
Construction condition: Single wire set in midair
Wiring length: 30 m or shorter
The following diagram shows the wires used for wiring. Use the wires given in this section or equivalent.
Example of selecting the wire sizes
Use the 600 V grade heat-resistant polyvinyl chloride insulated wire (HIV wire) for wiring. The following shows the wire size
selection example.
*1 Alphabets in the table indicate crimping tools. For crimp terminals and applicable tools, refer to the following.
 Page 566 Selection example of crimp terminals
*2 To connect these models to a terminal block, be sure to use the screws that come with the terminal block.
Selection example of crimp terminals
*1 Coat the crimping part with an insulation tube.
*2 Some crimp terminals may not be mounted depending on their sizes. Make sure to use the recommended ones or equivalent ones.
Servo amplifier Wire [mm
2
]
*1
L1/L2/L3/N-/ L11/L21
MR-J4-10GF-RJ 2 (AWG 14) 1.25 to 2
(AWG 16 to 14)
MR-J4-20GF-RJ
MR-J4-40GF-RJ
MR-J4-60GF-RJ
MR-J4-70GF-RJ
MR-J4-100GF-RJ
MR-J4-200GF-RJ 3.5 (AWG 12)
MR-J4-350GF-RJ
MR-J4-500GF-RJ
*2
5.5 (AWG 10): a 1.25 (AWG 16): a
2 (AWG 14): d
MR-J4-700GF-RJ
*2
8 (AWG 8): b
MR-J4-11KGF-RJ
*2
14 (AWG 6): e 1.25 (AWG 16): c
2 (AWG 14): c
MR-J4-15KGF-RJ
*2
22 (AWG 4): f
MR-J4-22KGF-RJ
*2
38 (AWG 2): g
Symbol Servo amplifier-side crimp terminal
Crimp terminal
*2
Applicable tool Manufacturer
Body Head Dice
a FVD5.5-4 YNT-1210S
 
JST
b
*1
8-4NS YHT-8S
 
c FVD2-4 YNT-1614  
d FVD2-M3
 
e FVD14-6 YF-1 YNE-38 DH-122
DH-112
f FVD22-6 YF-1 YNE-38 DH-123
DH-113
g FVD38-8 YF-1 YNE-38 DH-124
DH-114