Mitsubishi Electric MELSERVO-J4 series, Инструкция по эксплуатации

Страница: 491 / 646

14 USING A LINEAR SERVO MOTOR
14.4 Characteristics
489
14
14.4
Characteristics
Overload protection characteristics
An electronic thermal is built in the servo amplifier to protect the linear servo motor, servo amplifier and linear servo motor
power wires from overloads.
[AL. 50 Overload 1] occurs if overload operation performed is above the electronic thermal protection curve shown in the
following figures. [AL. 51 Overload 2] occurs if the maximum current is applied continuously for several seconds due to
machine collision, etc. Use the equipment on the left-side area of the continuous or broken line in the graph.
Use the linear servo motor with 70% or less of the effective load ratio when it is in the servo lock state or in a small
reciprocating motion.
This servo amplifier has linear servo motor overload protection. (The linear servo motor overload current (full load current) is
set on the basis of 120% rated current of the servo amplifier.)
a. LM-H3 series
LM-K2 series
b. LM-U2 series
c. LM-F series (natural cooling) d. LM-F series (liquid cooling)
1000
100
10
1
0.1
0 50 150 200 250 300 100
Operation time [s]
Load ratio [%]
Servo-lock
Operating
1000
100
10
1
0.1
0 200 300 400 100
Operation time [s]
Load ratio [%]
Operating
Servo-lock
1000
100
10
1
0.1
0 100 300 400 500 600 200
Operation time [s]
Load ratio [%]
Operating
Servo-lock
1000
100
10
1
0.1
0 50 150 200 250 300 100
Operation time [s]
Load ratio [%]
Operating
Servo-lock