Mindray iPM-9800, Руководство оператора

Страница: 287 / 300

D-3
Measurement Alarm messages L Cause and solution
CO2 CO2 Apnea H
AG Apnea H
The patient stops breathing, or the respiration signal
was so weak that the monitor cannot perform
respiration analysis. Check the patient’s condition and
the RM connections.
FiO2 Too Low H Check the patient’s condition, the ventilated O
2
content
and the AG connections.
AG
Anesthetic
Mixture’s MAC>3 M The system has detected more than one anesthesia gas
and the mixture’s MAC was too high. Check the
ventilated anesthesia gases’ type and concentration.
D.2 Technical Alarm Messages
Measurement Alarm message L I Cause and solution
XX SelfTest Err H C
XX Init Err H C
XX Comm Err L C
XX Comm Stop H C
XX
XX Comm
Abnormal L C
An error occurred to the XX module, or there is a
problem with the communications between the
module and the monitor. Restart the monitor.
XX Limit Err L C XX parameter limit is accidentally changed.
Contact your service personnel.
XX Overrange L C The measured XX value is not within the
specified range for XX measurement. Contact
your service personnel.
ECG Lead Off M
* B
ECG YY Lead Off
(YY represents a
leadwire.) M
* B
The electrode has become detached from the
patient or the lead wire has become disconnected
from the adapter cable. Check the connections of
the electrodes and leadwires.
ECG
ECG Noisy L C The ECG signal is noisy. Check for any possible
sources of signal noise around the cable and
electrode, and check the patient for great motion.