Mindray iPM-9800, Руководство оператора

Страница: 46 / 300

4-2
WARNING
z
[Patient Cat.] and [Paced] will always contain a value, regardless of whether the
patient is fully admitted or not. If you do not specify settings for these fields, the
patient monitor uses the default settings from the current configuration, which
might not be correct for your patient.
z
For paced patients, you must set [Paced] to [Yes]. If it is incorrectly set to [No], the
patient monitor could mistake a pace pulse for a QRS and fail to alarm when the
ECG signal is too weak.
z
For non-paced patients, you must set [Paced] to [No].If it is incorrectly set to [Yes],
the patient monitor may be unable to detect premature ventricular beats (including
PVCs) and perform ST segment analysis.
4.2 Editing Patient Information
To edit the patient information after a patient has been admitted, or when the patient
information is incomplete, or when you want to change the patient information:
1. In the main menu, select [
Patient Setup
>>].
2. Select [
Patient Demographics
] and then make the required changes.
3. Select [
Ok
].
4.3 Discharging a Patient
To discharge a patient:
1. In the main menu, select [
Patient Setup
>>].
2. Select [
Discharge Patient
] or [
Clear Patient Data
]. In the popup menu, you can:
‹
Directly select [
Ok
] to discharge the current patient, or
‹ Select [
Standby
] then [
Ok
]. The patient monitor enters the standby mode after
discharging the current patient, or
‹
Select [
Cancel
] to exit without discharging the patient.
3. If a printer is connected to your patient monitor, you can select [Print End Case Report]
to print all contents that you are setting up to print as an End Case report before
discharging the patient. After printing is completed, the patient monitor will
automatically enter the standby mode or return to the main screen, depending on your
previous setting.