Maeda MC815C, Руководство по эксплуатации, Страница: 379 / 426

369
10. Rotate the No.1 fly jib (2) using the position pins (C1, C2)
on the right section of the fly jib mounting bracket as pivot
points.
NOTES
To rotate the No. 1 fly jib (2), pull the tip of the No. 1 fly jib (2).
Also, if the No. 1 fly jib (2) rotation speeds up, prevent it from
doing so.
11. Insert the position pin (A2) to the bracket (27) on the left
section of the main boom tip. When doing so, attach the
shaft lock pin to prevent pins from falling.
NOTES
You need this position pin (A1) later to fix the fly jib.
12. Put the No.1 fly jib (2) rotated in step 10 on top of the fly jib
stowage bracket A (21) and align the holes.
13. After aligning the hole on the No. 1 fly jib (2) connection
section with the hole on the fly jib stowage bracket A (21),
insert the position pin (B2) into the hole and insert the
linchpin. Remember to turn the ring back to lock it securely.
• Do not remove the position pins (C1, C2) from the right section of the fly jib mounting bracket
(26), until the position pin (B2) is securely inserted into the hole of stowage bracket A (21) and
the fly jib is fixed. If you remove, it may cause a serious accident.
• The position pin (B2) must be inserted from above facing downwards. Otherwise, the position
pin might come off, and the fly jib may fall causing a serious accident.
CAUTION
Do not perform extend/retract operation with the position pins (B2, C1, C2) inserted into both
the holes on the right section of the fly jib mounting bracket (26) and the stowage bracket A (21).
If you perform the above, the fly jib and the main boom might be seriously damaged.