
24
TEMPORARY STORAGE WHEN ABNORMALITY IS FOUND WITHIN MACHINE
In case the Machine is found with an abnormality and is
therefore stored temporarily waiting for service, apply
following measures to notify all persons in the office that “the
use is prohibited due to failure.”
• Put on warning tags on the operation lever and other
applicable parts.
Write clearly the information such as abnormality contents,
name and contact of the storage manager, and the term of
storage.
• Keep it immovable when parking by, for instance, putting the
blocks on the crawler as pawls.
• Pull out the engine key and keep it with you.
PROVISION OF FIRE EXTINGUISHER AND FIRST AID BOX
Always observe the following to prepare for injuries and fires.
• To prepare in case of fire, decide on a location and install a
fire extinguisher, and make sure to read the label for terms
of usage.
• Decide the location to store the first aid box. In addition,
inspect the first aid box periodically and replenish the
contents as necessary.
• Decide the measures to take upon an injury or fire accident.
• Decide how to contact the emergency address (for instance
the emergency physician, ambulance or fire department),
and put up the contact address at designated position so
that anyone can make the contact.
DO NOT RUSH AND BE CAREFUL WHEN OPERATING
• Do not attempt sudden lever operation or harsh driving.
• When 2 or more cranes are within close proximity to each
other, drive with care while paying attention to tip-over
accident due to mutual contact. If in doubt, appoint a guide
to prevent machine contact.
•
When any abnormality or danger occurs during the
operation, abort the operation immediately to avoid hazard.
• Abort the work under bad weather (heavy rain, strong wind,
thunder, thick fog).
Decide whether to abort working by referring to the “work
abort decision standard” in the work schedule and by
discretion of the work supervisor of the site.
DO NOT MODIFY
Do not modify the Machine without our written consent under any circumstances.
The modification raises a safety issue, so consult us or our sales service agency beforehand.
We cannot be held responsible for any personal injury or failure caused by modification that
was performed without consulting us.
Содержание MC815C
