Maeda MC815C, Руководство по эксплуатации, Страница: 35 / 426

25
SAFETY WHEN REFILLING FUEL
• Diesel fuel is used as the fuel of this Machine.
Do not refill wrong kind of fuel.
Refilling with the wrong kind of fuel may damage the engine.
• Always stop the engine before refilling the fuel.
Refilling the fuel when engine is running may cause leaked
fuel to draw fire from hot silencer or other substance.
• Overfilling the fuel results in spillage and is dangerous.
Refill slightly lower than the specified level.
Always wipe away cleanly whenever the fuel spills.
• Close the tank cap securely after replenishing the fuel.
KEEP FIRE AWAY FROM OIL
Attempt to let fire approach the fuel, hydraulic oil or engine oil
may result in catching fire. Strictly observe the following.
• Do not allow any flames such as cigarettes or matches near
flammable components.
• Securely close all of the fuel and oil container caps.
• Keep the fuel and oil in a well-ventilated location.
• Store the fuel and oil in a specified location and prohibit
public access.
• Do not leave the site when replenishing the fuel or oil.
Be especially careful to observe “Safety when refilling fuel”
(described earlier in this manual), when replenishing fuel.
• Cleanly wipe away fuel or oil that is spilled during
replenishment.
HANDLING AT HIGH TEMPERATURE
After stopping machine operations, the engine and engine oil,
cooling water and hydraulic oil are hot for a short duration.
There can also be a small accumulation of pressure within the
hydraulic oil tank. Attempts to inspect the engine, remove the
radiator cap, drain oil, drain water or replace the filter at this
time will result in burns. Wait until the temperature drops.
When removing the filler cap of the hydraulic oil tank, follow
the procedure below.
1. To prevent emission of the high temperature oil, stop the
engine and wait until the oil temperature drops.
2. Loosen the cap and then turn it slowly to let the pressure
out.
3. Remove the cap.
(To gauge the drop in oil temperature, place a hand near the
surface of the hydraulic oil tank or similar location (making
sure of no contact.))