Maeda MC815C, Руководство по эксплуатации, Страница: 370 / 426

360
13. Pull out the No. 1 fly jib (2) toward you using the position
pins (C1, C2) of the right section of the fly jib mounting
bracket as pivot points and rotate it forward of the main
boom.
When pulling out the fly jib, do not enter the area in the direction
of pulling it out.
14. Align the holes (C, D) on the left section of the fly jib
mounting bracket (27) with the hole of the fly jib base (4).
15. Insert the position pin (A1) to the hole (D), then insert the
shaft lock pin. When doing so, be sure to lock the pin
securely with the retaining latch.
Then, remove the lever block (23) attached to the No.1 fly
jib (2) and the fly jib base (4) to prevent the fly jib from
falling.
16. Attach the wire (13) and the lever block (23) to the main
boom and the fly jib base (4).
CAUTION
When attaching the wire (13) and the lever block (23), pay
attention not to damage any electric wires in the vicinity.
17. Align the positions of the hole (C) on the left side of the fly
jib mounting bracket (27) and the hole of the fly jib base
(4) using the lever block and insert the position pin (A2) to
the hole, then push in the shaft lock pin. When doing so,
be sure to lock the pin securely with the retaining latch.
The position pin (A1, A2) must be inserted from above
facing downwards. Otherwise, the position pin might
come off, and the fly jib may fall causing a serious
accident.
NOTES
If you have any difficulties inserting the position pins (A1, A2),
try changing the order of pins to insert.