Section 6: SCPI command reference
Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual
6-188
DMM7510-901-01 Rev. B / May 2015
•
Inside: The measurement is inside the values set by limits A and B; limit A must be the low value
and Limit B must be the high value
•
Outside: The measurement is outside the values set by limits A and B; limit A must be the low
value and Limit B must be the high value
The measurement block must be a measure or digitize building block that occurs in the trigger model
before the branch-on-constant-limits block. The last measurement from a measure or digitize building
block is used.
If the limit A is more than the limit B, the values are automatically swapped so that the lesser value is
used as the lower limit.
Example
TRIGger:BLOCk:BRANch:LIMit:CONStant 5, OUTside, 0.15, 0.65, 8
Configure trigger block 5 to check for measurements in the last measure or digitize block. If the
measurements are outside of the 0.15 and 0.65 limits, branch to block 8.
Also see
(on page 3-85)
:TRIGger:BLOCk:BRANch:LIMit:DYNamic
This command defines a trigger model block that goes to a specified block in the trigger model if a measurement
meets user-defined criteria.
Type
Affected by
Where saved
Default value
Command only
Recall settings
Instrument reset
Power cycle
Save settings
Not applicable
Usage
:TRIGger:BLOCk:BRANch:LIMit:DYNamic <blockNumber>, <limitType>, <limitNumber>,
<branchToBlock>
:TRIGger:BLOCk:BRANch:LIMit:DYNamic <blockNumber>, <limitType>, <limitNumber>,
<branchToBlock>, <measureBlock>
<blockNumber>
The sequence of the block in the trigger model
<limitType>
The type of limit (
ABOVe
,
BELow
,
INside
, or
OUTside
)
<limitNumber>
The limit number (
1
or
2
)
<branchToBlock>
The block number of the trigger model block to execute when the limits
are met
<measureBlock>
The block number of the measure or digitize block that makes the
measurements to be compared; if this is
0
or undefined, the trigger model
uses the previous measure or digitize block
