Keithley DMM7510, Справочное руководство

Страница: 51 / 1036

Section 2: General operation Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual
2-24 DMM7510-901-01 Rev. B / May 2015
DC voltage measure settings
The following options are available on the Measure Settings menu when the function is set to DC
voltage.
Setting Description
Range
Determines the full-scale input for the measurement; also affects
the accuracy of the measurements and the maximum signal that
can be measured. Refer to
Ranges (on page 3-3).
Auto Delay
Applies a wait period at the start of measurement to allow cables
and circuitry to settle for best accuracy. Refer to
Auto Delay (on
page 2-137).
Display Digits
Sets the number of digits that are displayed for front-panel
readings. It does not affect accuracy or speed. Refer to
Setting the
number of displayed digits (on page 2-55).
Input Impedance
Sets impedance to Auto or 10 M
Ω
. Refer to DC voltage input
impedance (on page 2-98).
Unit
Allows voltage to be measured in volts or decibels. Refer to Show
voltage readings in decibels (on page 2-98).
Integration Rate
Controls the amount of time the input signal is measured
(aperture), which affects the noise and reading rate; see
Using
aperture or NPLCs to adjust speed and accuracy (on page 4-1).
Auto Zero
Determines if internal reference points are used to maintain
stability and accuracy. See
Automatic reference measurements (on
page 2-149).
Count
Sets the number of aperture readings that are processed when a
measurement is requested.
Line Sync
Enables or disables line synchronization. When it is enabled, it
helps increase common-mode and normal-mode noise rejection.
Refer to
Line cycle synchronization (on page 4-1).
Decibel Reference
Sets decibel reference point; this setting is only available when Unit
is set to Decibel. Refer to
Show voltage readings in decibels (on
page 2-98).