Cycles
Setup the number of cycles the Output must run.
Valid entries:
1 to 31 or unlimited cycles.
Default:
1 cycle.
+
Outputs that have
Unlimited
set for the
Output
op-
tion come back to standby ONLY when you en-
ter/exit to/from Installer Menu or download the
options to BOSS, therefore this value should be set
carefully.
The Output will continue to run the programmed num-
ber of Cycles even after the triggering event has been
cleared. During each cycle, the Output will be active for
the programmed
ON Time
and will restore to standby
for the programmed
OFF Time
. If an
Half Cycle
has
been programmed, the Output will oscillate in accor-
dance with the Half Cycle parameters (during the
ON
Time
), as shown in Figure 27.
+
The
Cycles
option can be set for Monostable Out-
puts only.
Half Cycle
If this option is other then zero, the Output
will remain active for the programmed time, return to
standby for the same amount of time, and then reacti-
vate, as shown in Figure 27. This option can be used to
generate visual and audible signals (cause LEDs to
blink or buzzers to sound).
Valid entries:
200 through 1400 milliseconds in 200
milliseconds steps.
If you set 0, the Output will not oscillate.
Partitions
If disabled (default) the output is NOT as-
signed to the area.
If ENABLED, the output is assigned to the Partition:
Ø
the output can be activated/deactivated from the
keypad ONLY if the PIN and the keypad used share
at least one Partition with those of the output;
Ø
the output can be activated/deactivated by telephone
ONLY if the PIN used shares at least one area with
those of the output.
+
These options are available ONLY for the
Re-
served
outputs.
Voice Messages
This Option Group will allow you to manage voice mes-
sages. This Control Panel can store up to
206
mes-
sages:
1
Long 12-sec Message;
205
short 6-sec
messages.
You can record the Voice Messages via a microphone
connected to the PC or you can load a prerecorded
messages from the PC resources (hard disk, LAN, etc.)
+
This Control Panel supports WAVE audio files
(.WAV), with different specifications. Possible con-
version errors are handled: logged and displayed
to the user.
RECORD button:
press to start recording of the
voice message.
LOAD button:
click to load a recorded voice mes-
sage from the PC resources (hard disk, LAN, etc.).
SAVE button:
click to save the voice message on
the PC resources (hard disk, LAN, etc.).
ERASE button:
click to delete the voice message.
PLAY button:
click to listen to the voice message.
PAUSE button:
click to pause playing or recording
of the voice message.
STOP button:
click to stop playing or recording of
the voice message.
When recording a message, a counter indicates (in real
time) the time elapsed.
e
In order to comply with the EN50131-1 and
EN50131-3 standards, reserved messages for
alarm, tamper, fault and automatic arming refused
(from No. 2 to No. 9 and No. 13) should NOT be
modified. If there is a
Hold-Up
Zone, its message
should NOT be changed (No. 14).
58
Expandable Hybrid Control Panel
Содержание Bentel Security tyco ABS128M50
Страница 14: ...14 Expandable Hybrid Control Panel...
Страница 98: ...98 Expandable Hybrid Control Panel...
