Johnson Controls Bentel Security tyco ABS128M50, Руководство по установке

Страница: 26 / 132

Ter. DESCRIPTION v(V) i(A)
NC
COM
NO
Programmable Output n. 1
(changeover switch contacts)
(4) 2
+N Programmable Output n. 1 (intrin-
sic security), protected by fuse 13.8
(2)
1.5
(1)
+A Programmable Output n. 1 (posi-
tive), protected by fuse 13.8
(2)
1.5
(1)
+B Positive power supply to periph-
erals, protected by fuse (will be
powered by the battery during
Mains failure) 13.8
(2)
1.5
(1)
M
Negative 0 –
O1 Programmable Output n. 2
(Open-Collector)
0 0.1
O2 Programmable Output n. 3
(Open-Collector)
0 0.1
AS 10 K
W
Supervised Tamper Line – –
RED
BLK
SPK
MIC
Terminals for the Audio Station:
Positive protected by fuse
Negative
Speaker
Microphone
13.8
(3)
0.5
(1)
+
C
R
–
BPI bus for the BPI peripherals:
Positive protected by fuse
Command
Response
Negative
13.8
(2)
1.5
(1)
Ter. DESCRIPTION v(V) i(A)
(5)
RED
BLK
YEL
GRN
Bus for the transceiver:
Positive protected by fuse
Negative
Receiver
Data
13.8
(3)
0.5
(1)
+F Power supply to detectors ( posi-
tive ), protected by fuse (will be
powered by the battery during
Mains failure)
13.8
(2)
1.5
(1)
T1
:
T4
Terminals programmable as In-
put Line or Output. – –
L1
:
L4
Programmable Input Line – –
M
Negative 0 –
LE External telephone line terminals – –
LI Line-sharing devices terminals (for
Answerphone, telephone, fax, mo-
dem, etc.) – –
-
Earth Terminal 0 –
e
At default, inputs L1, L2, L3 and L4 are pro-
grammed to signal the following events:
L1 = Detector fault
L2 = Hold-up device fault
L3 = Internal siren fault
L4 = External siren fault.
In order to comply with the EN50131-3 and
EN50131-1 standards, these settings must NOT
be changed.
26 Expandable Hybrid Control Panel
+ C R –
BPI device
C R + –
BPI device
R C + –
Panel
Power station
R C
+
R C
+
BPI IN BPI OUT
BPI device
R C + –
Figure 9 Connection of 4 BPI Devices
N. ADDRESS
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32
1
(1) 2
(2) 3
(3) 4
(4) 5
Table 5 Assignment of addresses: column N. shows the microswitch numbers (refer to the number in parentheses for
the power feeding supply address settings); a white square indicates that the respective microswitch must be OFF
and a gray square indicates that the respective microswitch must be ON.