SECTION 11—CONTROLLER
Zoom 300 and Zoom 400
78
Part No 1122167
Resetting Circuit Breaker
WARNING
NEVER defeat or bypass the circuit breaker. ONLY replace with a circuit breaker
with same rating.
If a circuit breaker repeatedly trips, DO NOT use the scooter. This may indicate
that a short circuit condition exists. Investigate potential causes and correct before
returning scooter to service.
NOTE: For this procedure, refer to FIGURE 11.6.
NOTE: Key must be removed from ignition before resetting circuit breaker.
1. Remove the seat. Refer to Removing/Installing the Seat on page 19.
2. Remove the rear shroud. Refer to Removing/Installing the Rear Shroud on page 30.
3. To reset, do one (1) of the following:
• For Zoom 300 - Press circuit breaker button located at rear of the controller tray.
• For Zoom 400 - Press circuit breaker button located at front of controller tray.
4. Reverse STEPS 1-2 to reassemble the powered scooter.
FIGURE 11.6
Replacing/Resetting the Circuit Breaker - Resetting Circuit Breaker
Circuit Breaker
Button
Top View of Scooter
Circuit Breaker Button
(under scooter frame)
Top View of Scooter
DETAIL “A” - ZOOM 300
DETAIL “B” - ZOOM 400
Scooter Frame
Controller
Tray
Rear Frame
Assembly
Controller
Tray
