SECTION 15—SCOOTER ACCESSORIES
Zoom 300 and Zoom 400
112
Part No 1122167
Installing/Removing/Using the Walker Holder
INSTALLATION WARNINGS
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely.
The installation of the walker holder onto the back of the scooter seat significantly
increases the length of the scooter. When turning the scooter or swiveling the
scooter seat, it is important to take note of this increased length - otherwise, injury
and/or damage to the surrounding property may result.
Installing/Removing the Walker Holder
NOTE: For this procedure, refer to
FIGURE 15.5.
NOTE: Reverse this procedure to remove the
walker holder.
1. If necessary, loosen but do not remove
the mounting knob.
2. Install the walker holder into the
accessory tube.
3. Thread the mounting knob into the
welded nut on the accessory tube.
Securely tighten.
FIGURE 15.5
Installing/Removing the
Walker Holder
Using the Walker Holder
NOTE: For this procedure, refer to
FIGURE 15.6.
1. Fold walker. Refer to walker
instructions.
NOTE: Walker MUST be folded before using
walker holder.
2. Hang folded walker on walker holder
hooks.
3. Secure walker with hook and loop
straps.
FIGURE 15.6
Using the Walker Holder
Seat
Accessory
Tube
Mounting
Knob
Walker Holder
Hook
Hook and
Loop Strap
