SECTION 6—SHROUDS
Part No 1122167
31
Zoom 300 and Zoom 400
Removing/Installing the Front Shroud
Zoom 300
NOTE: For this procedure, refer to FIGURE 6.2.
NOTE: Reverse this procedure to install the front shroud on the scooter frame.
1. Remove the seat. Refer to Removing/Installing the Seat on page 19.
2. Remove the rear shroud. Refer to Removing/Installing the Rear Shroud on page 30.
3. Remove the batteries. Refer to Removing/Installing the Batteries on Zoom 300 on
page 86.
4. Disconnect the tiller wiring harness from the rear wiring harness. Refer to
FIGURE 8.13 on page page 56.
5. Disengage the boot from the front shroud. Refer to Removing/Installing the Boot
Assembly on page 33.
6. Slide the boot up the tiller.
7. Remove the tiller. Refer to Removing/Installing the Tiller on page 40.
8. Remove the floormat on the front shroud by pulling up and away.
9. Remove the four (4) mounting screws that secure the front shroud to the scooter
frame.
10. Once the tiller is removed, slide the boot off the tiller and front shroud off the scooter.
FIGURE 6.2
Removing/Installing the Front Shroud - Zoom 300
Front Shroud
Mounting Screws
Boot Assembly
NOTE: Floormat, Tiller and Fork Assemblies, and Scooter frame are not shown.