SECTION 6—SHROUDS
Zoom 300 and Zoom 400
30
Part No 1122167
SECTION 6—SHROUDS
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power OFF and
remove key from ignition.
Removing/Installing the Rear Shroud
NOTE: For this procedure, refer to FIGURE 6.1
.
Removing
1. Remove the seat. Refer to Removing/Installing the Seat on page 19.
2. Disengage the hook-and-loop strips securing the rear shroud to the frame by pulling
up on the shroud.
3. Lift the rear shroud off the seat post.
Installing
1. Align the tabs on the rear shroud with the slots in the front shroud.
2. Place rear shroud on the frame and press down slightly to engage the hook-and-loop
strips on the rear shroud (not shown) with those on the scooter frame.
3. Install the seat. Refer to Removing/Installing the Seat on page 19.
FIGURE 6.1
Removing/Installing the Rear Shroud
Rear Shroud
Tabs
Seat Post
Frame
Front Shroud
Rear
Shroud
Tabs
Seat Post
Frame
Front
Shroud
DETAIL “A” - ZOOM 300
Location
of Slots
DETAIL “B” - ZOOM 400
Hook-and-Loop
Strips
Hook-and-Loop Strips
Hook-and-Loop
Strips
