IBM eServer 240 xSeries, Руководство пользователя

Страница: 127 / 219

POST message Description
662 A diskette drive configuration error occurred.
Action: If you removed a diskette drive, make sure that the diskette drive setting is
correct in the Configuration/Setup Utility program. If the setting is not correct,
change it. For information about using the Configuration/Setup Utility program, see
“Using the Configuration/Setup Utility main menu” on page 21.
If the problem persists, have the system serviced.
962 A parallel port configuration error occurred.
Action: If you changed a hardware option, make sure that the parallel port setting
is correct in the Configuration/Setup Utility program. If the setting is not correct,
change it. For information about using the Configuration/Setup Utility program see
“Using the Configuration/Setup Utility main menu” on page 21.
If the problem persists, have the system serviced.
11xx An error occurred during the system-board serial port test.
Action: If you have a modem, serial printer, or other serial device attached to your
server, verify that the serial cable is connected correctly. If it is, use the following
procedure:
1. Turn off the server.
2. Disconnect the serial cable from the serial port.
3. Wait five seconds; then, turn on the server.
If the POST error message does not reappear, either the serial cable or the device
is probably failing. See the documentation that comes with the serial device for
additional testing information.
If the POST error message reappears, have the system serviced.
1162 The serial port configuration conflicts with another device in the system.
Action:
1. Make sure the IRQ and I/O port assignments needed by the serial port are
available. (See Chapter 3, “Configuring your server.”)
2. If all interrupts are being used by adapters, you might need to remove an
adapter to make an interrupt available to the serial port, or force other adapters
to share an interrupt. For information about removing adapters, see “Working
with adapters” on page 53. For information about setting interrupts, see
Chapter 3, “Configuring your server.”
1301 Cable to Information LED panel not detected.
Action: Make sure that the cable to the operator information panel is connected.
If the problem persists, have the system serviced.
1302 Cable to Power and Reset pushbuttons not detected.
Action: Make sure that the cable to the Power and Reset pushbuttons is
connected.
If the problem persists, have the system serviced.
1303 I2C cable to Power Backplane not detected.
Action: Make sure that the cable to the power backplane is connected.
If the problem persists, have the system serviced.
1304 Cable to Diagnostic LED panel not detected.
Action: Make sure that the cable to the diagnostic LED panel is connected.
If the problem persists, have the system serviced.
Chapter 6. Solving problems
117