IBM eServer 240 xSeries, Руководство пользователя

Страница: 168 / 219

Note: After you replace the battery, you must reconfigure your server and reset
the system date and time.
To replace the battery:
1. Turn off the server and peripheral devices and disconnect all external cables
and power cords (see “Preparing to install options” on page 46); then remove
the cover (see “Removing the left-side cover (tower model)” on page 48 or
“Removing the cover (rack model)” on page 49).
2. Locate the battery on the system board (see “System-board component
locations” on page 99).
3. Remove adapters to allow access to the battery. (See “Installing a hot-plug
PCI adapter” on page 56 for information about installing and removing adapters
from the hot-plug PCI slots.)
4. Remove the plastic dividers between the hot-swap PCI slots to allow access to
the battery.
5. Remove the battery:
a. Use one finger to lift the battery clip over the battery.
b. Use one finger to slightly slide the battery toward the rear of the server.
The spring mechanism behind the battery will push it out toward you as you
slide it forward.
c. Use your thumb and index finger to pull the battery from under the battery
clip.
d. Ensure that the battery clip is touching the base of the battery socket by
pressing gently on the clip.
6. Insert the new battery:
a. Tilt the battery so that you can insert it into the front of the socket, under
the battery clip.
b. As you slide it under the battery clip, press the battery down into the
socket.
158
IBM xSeries User's Reference