Hagie UpFront STS 16, Руководство пользователя

Страница: 198 / 341

SECTION 7 –
SPRAY SYSTEMS
7-57
Filling the Chemical Tank(s)
1. Ensure the Tank Drain Valves (upper
and lower) are in the OFF (Closed) posi-
tion.
2. Remove the Fill Port Lid (located on top
of the chemical tank) and set aside.
3. Pour product through fill port and fill
chemical tank to desired level.
4. Reinstall the Fill Port Lid.
Getting Started
NOTE: Ensure the Master Spray Switch
(located on the Hydrostatic Drive
Control Handle) is in the OFF
position before activating the
Solution Pump Switch or the Boom
Solution Valve Switches, unless you
are ready to begin spray application.
1. Calibrate the Spray System Console
(refer to the manufacturer’s operation
manual for calibration instructions).
2. Ensure there is adequate amount of
solution in the chemical tank(s) and
water in the main tank.
3. Rotate the Outlet Selector Valve(s)
(located on the front of injection
pump(s)) to the “TO BOOM” position.
NOTE: Refer to the provided label for valve
handle orientation. See following
illustration.
NOTICE
Never attempt to operate the Modular
Injection System without solution in the
tank(s). Failure to comply may result in
equipment damage and will void the
warranty.
Fill Port Lid
(Located on the top of chemical tank)
-Typical View
Outlet Selector Valve(s)
(Located on the front of injection pump(s))
-Typical View
* 1-tank/1-pump configuration show