Hagie UpFront STS 16, Руководство пользователя

Страница: 170 / 341

SECTION 7 –
SPRAY SYSTEMS
7-29
• Master Spray Switch
• Spray System Console
• Air Purge (if equipped)
• Wet Booms
• Nozzle Bodies
• Section Strainers (if equipped)
• Solution Line Strainer
Solution Tank
The 1600-gallon (6056 L) stainless steel
Solution Tank (located at the center of the
machine) is equipped with a spin ball-type
rinse system (two rotating rinse balls inside
the tank). A mechanical sight gauge is
located behind the left-hand side of cab to
visually check solution level at all times.
Solution Pump
Hypro® 9306-HM1C-BU w/silicon carbide
seals, 3” (7.6 cm) inlet/2” (5.1 cm) outlet
plumbing
The Solution Pump (located beneath
center of machine) is a centrifugal-type
hydraulically driven pump that is controlled
by the Solution Pump Control Valve and the
Spray System Console.
The Solution Pump draws solution out of
the tank at the rate determined during
calibration. It dispenses solution through the
many valves and hoses that make up the
spray system. The Solution Pump also
dispenses fluids through the Agitation and
Rinse Systems.
Refer to the Spray System Console
manufacturer’s operation manual for further
information on Solution Pump control.
Solution Pump Switch
The Solution Pump Switch (located on the
side console) is used to turn on/off the
Solution Pump.
NOTE: Leaving the Solution Pump Switch in
the ON position without flow may
result in system damage.
• Press the Solution Pump Switch in the
UP position to turn ON (enable).
• Press the Solution Pump Switch in the
DOWN position to turn OFF (disable).
Solution Tank
-Typical View
Solution Pump and
Solution Pump Control Valve
(Located beneath center of machine)
-Typical View
* View shown from top of machine
• Solution
Pump
• Solution
Pump
Control
Valve