Hagie UpFront STS 16, Руководство пользователя

Страница: 179 / 341

7-38
SECTION 7 –
SPRAY SYSTEMS
NOTE: Ensure the Master Spray Switch
(located on the Hydrostatic Drive
Control Handle) is in the OFF
position before activating the
Solution Pump Switch or the Boom
Solution Valve Switches, unless you
are ready to begin spray application.
Getting Started
1. Calibrate the Spray System Console
(refer to the manufacturer’s operation
manual for calibration instructions).
2. Ensure there is adequate amount of
solution in the tank.
3. Engage the parking brake.
4. Start the engine.
5. Press the Field/Road Button (located on
the Machine Display Home Page) and
change the machine’s drive state to
FIELD.
NOTE: The drive state of the machine
cannot be changed unless the
Hydrostatic Drive Control Handle is
in the NEUTRAL position (and
machine speed is less than 0.5 mph/
0.8 km/h).
NOTE: The selected drive state will
illuminate.
6. Position boom to desired position.
7. Press the Main Tank Valve Switch
(located on the side console) in the UP
(Open) position.
If desired, activate the Agitation Valve
Switch (located on the side console).
Press and hold switch UP to increase
flow, or DOWN to decrease flow.
NOTE: Main Tank Valve status (OPEN or
CLOSED) and Agitation Valve
pressure are displayed on the
Machine Display Home Page (Field
Mode).
NOTICE
Never attempt to operate the spray
system without solution in the tank.
Failure to comply will cause severe
equipment damage and will void the
warranty.
Field/Road Button
(Located on the
Machine Display Home Page)
Main Tank and Agitation Valve Switches
(Located on the side console)
-Typical View
• Main Tank
Valve Switch
• Agitation
Valve Switch