Hagie UpFront STS 16, Руководство пользователя

Страница: 216 / 341

SECTION 8 –
DUAL PRODUCT SPRAY SYSTEMS
8-2
Each Solution Pump draws solution out of
the corresponding tank side at the rate
determined during calibration. They
dispense solution through the many valves
and hoses that make up the solution system.
The pumps also dispense fluids through the
Agitation and Rinse Systems.
In Single Product Mode , the Primary
Solution Pump is always used. In Dual
Product Mode , both Primary and Secondary
Solution Pumps are used - the Primary
Solution Pump pulls from the 600-gallon/
2271L side (Tank 2), and the Secondary
Solution Pump pulls from the 1000-gallon/
3785L side (Tank 1).
Refer to the spray system console
manufacturer’s operation manual for further
information on Solution Pump control.
Solution Pump Switch
The Solution Pump Switch (located on the
side console) is used to turn on/off the
Primary Solution Pump.
NOTE: The Secondary Solution Pump is
controlled through the spray system
console.
NOTE: Leaving the Solution Pump Switch in
the ON position without flow may
result in system damage.
• Press the Solution Pump Switch in the
UP position to turn ON (enable).
• Press the Solution Pump Switch in the
DOWN position to turn OFF (disable).
NOTE: When the Primary Solution Pump is
ON, a Solution Pump Indicator
(located on the Machine Display
Home Page - Field Mode) will
illuminate.
Flow Meters (2)
(ARAG® Orion)
The dual Flow Meters (Primary Flow
Meter located beneath the center right-hand
side of machine, and Secondary Flow Meter
located near the front right-hand side of
machine) are an electromagnetic-type with
Solution Pumps - Primary/Secondary
(Located beneath rear of machine)
-Typical View
* View looking towards front of machine
• Primary
Solution Pump
• Secondary
Solution Pump
Solution Pump Switch - Primary
(Located on the side console)
-Typical View
Solution Pump Indicator - Primary
(Located on the Machine Display
Home Page - Field Mode)