Hagie UpFront STS 16, Руководство пользователя

Страница: 262 / 341

SECTION 9 –
MAINTENANCE AND STORAGE
9-4
2. Remove 8 o’clock plug (B). If no oil
comes out, proceed to Step 3.
3. If oil is needed, remove the top plug (C)
and fill until oil begins to come out of the
8 o’clock plug (B).
4. Reinstall plugs.
To change the oil:
NOTE: Wheel hub oil should be changed
after the first 50 hours of operation.
After that, it should be changed
every 250 hours of operation or
yearly, whichever occurs first.
1. Position wheel hub so one of the face
plugs is positioned at 6 o’clock and the
other plug is positioned at either the 3 or
9 o’clock positions.
2. Remove plugs to drain oil.
3. Once all of the oil is drained, reinstall the
bottom plug and remove the 3 or 9
o’clock plug.
4. Rotate wheel hub to the “fill” position so
one of the plugs is positioned at 12
o’clock and the other plug is positioned
at either the 3 or 6 o’clock positions.
5. Refill wheel hub with oil until satisfactory
level is met.
6. Reinstall plugs.
General Maintenance
If your machine is going to sit unused for
an extended period of time, occasionally
rotate the wheel hubs by driving the machine
forward and backward - at least half of a tire
rotation to adequately coat all internal wheel
hub parts. This will prevent rusting if moisture
inadvertently entered the wheel hub during
an oil change.
Engine Oil
The Engine Oil Dipstick is located inside
the oil fill on the left-hand side of engine
(remove cap to access). Wait at least five (5)
minutes after shutting the engine off to check
the oil level.
NOTE: Check the engine oil level daily.
Capacity
• Engine Oil Dipstick (low to high mark
capacity) = 2.3 quarts (2.2L)
• Engine Oil Pan Capacity (including filter,
remote lines, and cooler) = 34.4 quarts
(32.6L)
C
Full
Line
A
B
NOTICE
Failure to rotate the wheel hub and
disperse oil may cause rusting and
internal wheel hub damage.
NOTICE
Never operate the engine with oil level
below the “L” (low) mark or above the “H”
(high) mark on the engine oil dipstick.
NOTICE
The engine must be level when checking
oil level to ensure accuracy.