Hagie UpFront STS 16, Руководство пользователя

Страница: 292 / 341

SECTION 9 –
MAINTENANCE AND STORAGE
9-34
Tire Pressure
• Check tire pressure weekly.
• Never inflate a tire more than the maxi-
mum air pressure (as stated on the tire
sidewall or in the tire specifications table
provided in the
Introduction Section
of
this manual).
• Use an airline with a locking air chuck
and stand behind tire tread while filling.
NOTE: Tire pressure will depend on type of
tire used and amount of load.
Spray Booms
Nozzle Diaphragms
At the beginning of each season, remove
each nozzle body cap (A) and inspect the
diaphragm (B) for wear or fit. Replace
diaphragms every 1,000 hours of operation,
or as necessary.
Spray Tips
At the beginning of each season (or as
required), remove a random sample of spray
tip caps (C) and inspect the nozzle tips. If the
tips are plugged or worn, clean or replace
them. Replace spray tips every 1,000 hours
of operation, or as necessary.
NORAC
®
Sensor Foam Pads
Inspect the NORAC Sensor Foam Pads
daily. Remove the foam pad from each
sensor, blow out with compressed air, and
reinstall.
NOTE: Ensure foam pads are clean and dry
to ensure optimal performance.
NOTE: DO NOT blow the foam pad out
while still installed on the sensor.
Always remove foam pad before
cleaning to avoid sensor damage.
CAUTION
When inflating a tire, use an extension
with an in-line air gauge and attach air
chuck. This will allow the operator to
stand clear of tire sidewall explosion
trajectory.
Valve Stem (4)
(Located on the inside of each wheel)
-Typical View
CAUTION
Never place a spray tip/nozzle to your
mouth in an attempt to unplug it.
Nozzle Diaphragms and Spray Tips
-Typical View