GRAUPNER mz-24 PRO, Руководство по программированию

Страница: 5 / 240

... the currently active model memory is not linked to
any receiver. Tapping on the
SET button you accede
immediately the under-menu »
Transmitter setting
«,
…
... where you can bind your receiver or, tapping on the
BACK button at the top left of the display to terminate
the procedure.
Tip
The basic procedure for initially programming a new
model memory starts on page
42 .
Notices
• With this
mz-24
HoTT Pro transmitter it is
possible to control up to 12 functions. Any
servos which are connected to connections
13 and higher remain in their middle position
by default and cannot be actuated by the
transmitter as standard.
• For the sake of maximum flexibility and to pre-
vent unintentional misuse, control channels
5-12 are initially not assigned to any control el-
ements, and the servos linked to these chan-
nels first remain in their middle position until
an operating element has been assigned. For
the same reason, nearly all mixers are inactive.
Similarly you will find at the begin of the para-
graph's description "
CTL Set ".
• When training, linking or adjusting the remote
control, make sure that the transmitter anten-
na is always far enough from the receiver an-
tennas. If the transmitter antenna is too close
to the receiver antennas, the receiver will
overdrive, and the red LED on the receiver will
shine to indicate that no signal is received. At
the same time, the feedback channel will stop
working, the field strength bar in the transmit-
ter display will disappear, and the current re-
ceiver battery voltage will be displayed as 0.0
V. In this moment the transmitter is in the so
called
Fail safe mode . That is, due to the loss
of reception, the servos remain in the last cor-
rectly received positions or after a short time
in the preset Fail-Safe positions, until a new
valid signal is received. In this case, move the
two antennas away until the displays return to
normal.
CAUTION
Never turn off the transmitter while oper-
ating the model! If this nonetheless acci-
dentally happens, do not panic, and wait
until the transmitter display goes dark which indi-
cates that the transmitter is completely off. This
will take at least four seconds. After this time, turn
the transmitter on again. Otherwise, the transmit-
ter may freeze directly after being turned on, and
you will be unable to control the model any more.
The transmitter may only be turned on again after
it has been turned off and the described procedure
has been correctly repeated.
5 Starting up the transmitter