GRAUPNER mz-24 PRO, Руководство по программированию

Страница: 44 / 240

Entering the basic settings of a new model with
an assistant
The previous section described the basic manual
programming of a fixed-wing model. In the following,
the
assistant-controlled programming of a helicopter
model will be described. As the manual programming,
also the assisted programming follows always a pre-
defined program procedure.
Tip
Some of the following described sub-menus offer theo-
retically the possibility of phase-specific settings. Each
one indicated on the upper left side by the green colored
phase name "PHASE 1", for example:
Because within the assisted programming only settings
in the "Phase 1" (the normal phase) are possible, in this
context it will not be told much more about "phase spe-
cific settings". More about this point is explained in the
description of the single menu point.
As described under NEW in the section " Model se-
lection ", to set up a new model, select a free model
memory or model memory that has already been as-
signed but is no longer required.
After tapping on NEW a selection window will appear
in which you can select one option between manual
or assisted programming of the new model so as
NO
to interrupt the procedure:
In the following sub-menus, the options to configure
the required options will be proposed according to the
model type previously selected.
Since the programming of a helicopter with the help
of an assistant will be soon described in this section,
touch the
WIZ. button:
Touch
Tip
An example of manual model programming is described
in the previous section in the context of programming a
fixed wing model.
As previously described with reference to manual
model programming, basic programming is started by
entering a model name when programming a model
with an assistant.
"Model name"
Switch between uppercase and lowercase and vice
versa with the
CAPS button at the bottom edge of the
screen, and similarly, press the NUM button to go to
the numbers 0 … 9 and special characters.
Switch to the desired symbols chart and tap on the
first character of the model name.
To enter an empty space tap on the
[ Space ] but-
ton. You can select other special characters by touch-
ing the
SPECIAL button.
All other characters can be entered in the same man-
ner. A maximum of 15 characters can be entered for
a model name.
By touching
< [ DELETE ] in the bottom row of red
buttons, the last character is deleted. To delete all of
the entered characters at once, touch
<< [ CLEAR ].
The characters which are entered in this manner
appear in the blue field above the keypad in the se-
quence in which they are entered, for example:
44 Base menu - Model selection