GRAUPNER mz-24 PRO, Руководство по программированию

Страница: 95 / 240

At the same time as long as the automatic switch on
of the RF module is inhibited, until the throttle limit or
the throttle/pitch control stick let the output signal of
the channel 6 be out of the idle range.
Tip
View the " Servo monitor " to monitor the influence of
the throttle limit control. Be sure to remember that servo
output 6 controls the throttle servo in the
mz-24
HoTT
Pro transmitter.
Idle basic settings
Open the throttle limit until the end point. Move the
throttle/pitch control stick to the maximum pitch posi-
tion and, in the sub-menu...
» Throttle curve «
... of the function menu, make sure that the standard
gas curve is active.
If the standard gas curve has already been changed
after a model memory has been initialized, reset it (at
least temporarily) to "POINT L = 0%", "POINT 3 =
+50%" and "POINT H = +100%":
Notice
Since the throttle trimming lever does not work
when the throttle limiter is open, its position is ir-
relevant in this case.
Without starting the gas engine, adjust the throttle
servo (preferably mechanically), and if desired addi-
tionally by adjusting the travel of servo 6 in the sub-
menu "
E.P.A. " of the base menu to completely open
the carburetor.
Then completely close the throttle limiter, for exam-
ple by turning the proportional dial "DV 2" all the way
clockwise. Use the trimming control of the throttle/
pitch control stick to move the marking of the trim-
ming position into the motor OFF position.
Notice
The position of the throttle/pitch control stick is
irrelevant when the gas limiter is closed. It can
therefore remain in the maximum pitch posi-
tion as long as you can switch between full throttle
(throttle limiter open) and "Motor OFF" (throttle limit-
er closed) using just the throttle limiter when adjusting
the carburetor linkage.
While the gas limiter is closed, adjust the carburetor
linkage so that the carburetor is completely closed.
Make sure that the throttle servo does not mechan-
ically over-travel in the two extreme positions (full
throttle/motor OFF).
To conclude this basic setting, match the setting
range of idle trimming with point "L" of the gas curve.
Adjust point "L" of the "throttle curve" display to ap-
proxi15 to +18%, for example:
To precisely adjust a seamless transition from idle
trimming to the throttle curve, move the pitch control
stick back and forth slightly at the minimum stop while
the throttle limiter is closed and idle trimming is com-
pletely open. The throttle servo should not move. Any
subsequent adaptation of the gas curve must be done
later during flight.
The motor should always be started with the throttle
limiter completely closed. Adjusted the idle only with
the trimming control of the throttle/pitch control stick,
and turn off the motor with digital trimming.
95 Base menu - Control/switch setting | Throttle limit function