GRAUPNER mz-24 PRO, Руководство по программированию

Страница: 230 / 240

Programming example
Phase specific flaps trimming
The following described options offers you the possi-
bility to correct the trimming of the phase specific (and
at any time recallable) trimming of the flaps through
only
one control element in all the phases.
With this programming example, you must have al-
ready covered the description of the individual menus,
and you must be familiar with the use of the transmit-
ter. It is also assumed that the
Receiver connection
assignation has been performed according to what
written on page 32 and also that the model has
been completely programmed in the mz-24 HoTT Pro
transmitter and mechanically adjusted. In addition,
you should have been convinced by the correct lat-
eral deflection of all rudders. Also, it is by no means a
disadvantage, if the model has already the first flights,
as well as the resulting adjustments, behind it.
Programming
Switch your transmitter on and start programming the
flaps positions in the sub-menu ...
» Trim Step «
… of the basis menu:
In one of the two "DIGITRIM" lines tap on the normal-
ly labeled as
NONE | button and change its labeling
by tapping on the
+
- and alternatively
–
button in
"CH6":
Then change to the sub-menu ...
» P/MIX «
... of the functions menu and switch to the desired
phase.
Set in the desired phase the related number of mixers
according to the scheme "CH6 >> CH2" and "CH6
>> CH5" for left and right ailerons; "CH6 >> CH6"
and "CH6 >> CH7" for the flaps or for left and right
flaps so as – if included – "CH6 >> CH9" and "CH6 >>
CH10" for the second flaps pair.
For a model of the "2AILE 2FLAPS" type see as ref-
erence the display "Thermal" for example as follows:
Depending on the installation situation of your wing
servos as well as the desired operating direction of
the selected Digitrim button, the mixing direction of
the individual mixer pairs must be set individually. This
allows both contrasting ...
... as well as parallel mixing directions for each pair
of flaps, in both cases, the trimming distance (max.
37,5% at 125% admixture) is determined according
to the mixing proportion:
230 Programming example - Flaps trimming