GRAUPNER mz-24 PRO, Руководство по программированию

Страница: 27 / 240

Assigning logical switch or control
• Switch assignment
The places in the program where a switch, a logical
control or switch can be assigned are marked with
"CTL". So as for example as marked with a red cir-
cle in the penultimate line of the following picture
of the Dual Rate / Expo displays:
As soon as you tap on NONE , on the right near
CTL …
touch
... the window in the display will ...
... appear. Actuate the desired switch, for example
the front left 3-way switch S5:
Thus completes the assignation of the switch for
this menu.
• Switch setup
In other menus, in which the switches can be as-
signed, for example the "
PHASE " menu, …
... an accessory display will appear immediately af-
ter the switch assignation.
Completely independently from the yellow arrow,
which only indicates the actual position, you can
confirm in this display by touching the related but-
ton, in which position di selected phase should be
"ON", for example:
It has to be logically matched with the other switch
positions.
Notice
The phase 1, the "normal phase", is then al-
ways active when none of the assigned phase
switch is on the "ON" position.
If you choose the 2-stage switch SW 6 instead of
the 3-stage switch SW 1, the display appears as
follows:
Select the desired switching direction as above.
• Deleting switches
After the switching or control assignment has been
activated as described at the beginning of this sec-
tion, touch the
CLR button.
touch
27 Control and switch assignment