GRAUPNER mz-24 PRO, Руководство по программированию

Страница: 123 / 240

Attention
In the "AUTOROT" phase you should always
leave the standard 0.0s switch time, so that in
case of necessity you can switch to this phase
without delay.
Notice
The switchover time that is set here acts uni-
formly on all phase-specific settings as well as
all mixers that are activated in the Mixer menu.
The switchover between phase-dependent mixers
then also proceeds smoothly.
• "CTL" column (Control/switch)
In the previously described columns "phase"
and "DELAY", you assigned names to Phase1 ...
Phase6 and may have programmed switchover
times; however switching between the phase is
not yet possible. To enable this, touch the desired
value field in the "CTL" column, for example...
Touch
… and assign a switch or control switch as de-
scribed in section
Control and switch assignment .
Notices
• The phase 1, the "normal phase", is then
always active when none of the assigned
phase switch is on the "ON" position.
• To avoid function errors in no case a switch
which has been used or is going to be
used in the "
Announce " menu has to be
assigned as a phase switch.
• SET button
Touch the SET button at the upper right of the dis-
play opens a sub-menu …
... in which you can assign individual announc-
es related to the phases, as meanwhile usual, by
tapping on the respective value field and select
through the
+ or - buttons, for example:
After you have finished making your settings, touch
the
BACK
button at the top left of the display to return
to the menu selection:
123 Function menu | general - Phase