GRAUPNER mz-24 PRO, Руководство по программированию

Страница: 233 / 240

Programming example
Phase specific trimming
"RPM setting" of a governor connected to CH6
If you have programmed the speed setting of your
governor in the Heli program, you can use this option
with additional programming via one of the two dig-
itrim keys, eg DT2, to trim even during the flight.
With this programming example, you must have al-
ready covered the description of the individual menus,
and you must be familiar with the use of the transmit-
ter. It is also assumed that the
Receiver connection
assignation has been performed according to what
written on page 31 and also that the model has
been completely programmed in the mz-24 HoTT Pro
transmitter and mechanically adjusted. In addition,
you should have been convinced by the correct lat-
eral deflection of all rudders. Also, it is by no means a
disadvantage, if the model has already the first flights,
as well as the resulting adjustments, behind it.
Programming
Start programming this complement in the sub-menu
...
» TR. ST. «
... of the basic menu and assign to the line "DIG-
ITRIM2" in this particular case the throttle control
channel "CH6" to:
Then change to the sub-menu ...
» P/MIX «
... of the functions menu and switch to the desired
phase.
Now create a
same-channel mixer "CH6 >> CH6",
possibly in any desired phase ...
Then, on the setting side of this mixer / these mixers,
define a symmetrical mixing proportion of, for exam-
ple, 50 %:
Please note that the operating direction of the digitrim
pushbutton from the mixing direction and the trim-
ming distance (max. 37.5% at 125% admixture) are
determined proportionally from the adjusted mixing
ratio.
233 Programming example - Trimming an rpm presetting