GRAUPNER mz-24 PRO, Руководство по программированию

Страница: 10 / 240

3. In the sub-menu »TX ctl« , depending on the num-
ber of channels used for the connected flight sim-
ulator or for the Training mode, you can select in
the line "DSC output" one of the following modes:
PPM10, PPM16, PPM18 und PPM24. Default set-
ting: PPM10.
Notice
Given the numerous flight simulators on the mar-
ket, it is possible that the contacts on the jack
plug or DSC module may have to be adapted by
Graupner Service.
Attention
When your transmitter is directly connected to a
desktop computer or laptop by a connecting ca-
ble (DSC cable) and/or a computer interface is
connected to your simulator, the transmitter may be de-
stroyed by electrostatic discharge. This type of connec-
tion should therefore only be used if you protect yourself
from electrostatic discharge while operating the simula-
tor by wearing a commercially available grounding arm-
band.
Graupner therefore strongly recommends only
using wireless simulators.
DSC socket
The abbreviation "DSC" is from the initial letters of the
original function, "direct servo control". With the HoTT
system, "direct servo control" using a diagnostic ca-
ble is not possible for technical reasons.
The standard two-pin DSC socket on the back of the
mz-24 HoTT Pro transmitters functions as a TRAINER
or PUPIL socket as well as an interface for flight sim-
ulators or other external devices.
To ensure a correct DSC connection, observe the
following:
1. Perform any necessary adaptations in the menu.
To adapt to the transmitter to a trainer system, see
the description of the "
Trainer " menu.
2. Connect the other end of the connecting cable to
the desired device while observing the relevant op-
erating instructions.
Tip
Make sure that all the plugs are securely inserted in
the respective sockets, and only use the provided
plug-in connections with a 2-pin jack plug on the
DSC side.
The so-called DATA socket is found under the back
cover of the
mz-24 HoTT Pro transmitters:
This is for connecting the optional Smart Box ( order
No.
33700) or alternatively for an external Bluetooth
module (No. S8351 ).
Further information on the Smart Box and the Blue-
tooth module can be found in the main
Graupner FS
catalogue and on the Internet at www.graupner.de for
the respective product.
Data socket
10 Connection on the back side