GRAUPNER mz-24 PRO, Руководство по программированию

Страница: 47 / 240

"E.P.A." (Servo travel/limit)
Tip
In order to set control channels with numbers higher
than CH6, touch
NEXT [ change page ].
The travel and limitation are shown separately for
each side in this display. The setting range in both
cases is 0 … 150% of the normal travel.
The set values always refer to the settings in the sub-
menu "
REV/SUB ".
To change a current value, touch the desired option
field, for example:
Touch
The selected option field will be marked in blue:
Touch the + button at the right edge of the display to
gradually increase the value of the active option field.
Touch the
–
button underneath to reduce the current
value of the active option field, and touch the RES
button to reset the changed value back to the default.
Once all you have adjusted all of your servos, touch
the
WIZ. button at the top left to switch to the next
adjustment phase:
"D/R,EXP"
The dual rate/expo function allows you to switch or
influence the control deflections and characteristics
for the control functions of roll, nick and tail rotor, i.e.
control functions 2 … 4 through switch.
Dual Rate acts, as the control setting in the sub-
menu " Ctl.SET ", directly on the related Control func-
tion , independently from the fact that the function is
associated to a single servo or i actuated thorough a
complex mixer or coupling function by many different
servos.
The control deflections can be set for each switch
position between 0 and 125% of the normal control
travel.
EXP allows a more sensitive control of the model in
the central position of the respective control function
(roll, nick and tail rotor) for values greater than 0%
without having to do without the complete deflection
in the end position of the control stick.
Conversely, the effect of the control around neutral
position increases for values less than 0% and de-
creases in the direction of the full deflection. The pro-
gression can be set from -100% to +100%; 0% cor-
responds to the normal linear control characteristic.
The EXP setting always acts directly on the corre-
sponding control function independent of whether
it affects the individual servo or several servos by
means of complex mixing and coupling functions.
By default, the dual rate and/or expo values are set for
each control side. After switching the option "
SYM "
from OFF to …
Touch
... to ON , a symmetrical, that is joint, setting of both
control sides is possible.
In the graphic of the display, the curve characteristics
are shown directly.
Tip
After having completed the program assisted model pro-
gramming and the setting of the phases in the "
PHASE "
sub-menu of the functions menu all the options con-
tained in the Dual rate/Expo phase specific menus can
be programmed.
Programming
Between the setting displays of individual control
functions, alternatively touch the button on the right
near the yellow "C" (channel) with a finger or the pro-
vided stylus:
47 Base menu - Model selection