GRAUPNER mz-24 PRO, Руководство по программированию

Страница: 99 / 240

• The model or sensors may only be
programmed when the model is on the
ground. Only perform settings when
the motor is turned off or the drive
battery is disconnected. Otherwise,
unanticipated reactions may occur.
A servo test that is accidentally ac-
tivated in the receiver, for example,
could cause the model to crash and
cause injury or property damage.
• In addition, consult the safety instruc-
tions contained in the Part 1 of the
manual included in the transmitter
package.
Telemetry
The menus that fall under the generic term of "
Telem-
etry
" can be accessed from the "free" function menu
of the mz-24 HoTT transmitter. You can open this
function menu by touching the gear icon labeled "B":
Touch
Touch
Tap on the "Telemetry" icon to open the first page of
the telemetry display:
Basic operation
Basically the " Telemetry " menu corresponds to the
other menus of the mz-24 HoTT Pro transmitter: The
few deviations are described below:
If you have bound a receiver as RX1 or also as RX2 in
the sub-menu "
TX ctl ", then you can declare one of
the two receivers as "Telemetry-receiver" by tapping
on the standardly
RX1
labeled value field. As stan-
dard it is the last bound one. To change the standard
setting
ALWAYS on the right according to your pref-
erence, tap on the value field. The color of the value
field changes from black to blue:
Set the desired value with the
+
or
–
button at the
right edge.
Value Explanation
ALWAYS The transmitter reacts standardly
to the back-channel of the selected
receiver.
4x / 8x The transmitter reacts to the
back-channel of the selected receiver
with the related delay.
OFF The transmitter telemetry functions
are switched off.
Notice
Actually the use of settings different from the
standard value
ALWAYS is only suggested if
two receiver, which are not connected to each
other and which are bound to two different transmitters,
are intended to use in close distance and therefore there
are oft disturbs in the back-channel of one of both re-
ceivers.
99 Function menu - Telemetry