GRAUPNER mz-24 PRO, Руководство по программированию

Страница: 116 / 240

Touch the corresponding button ...
Touch
… to open the selected sub-menu:
REPEAT
To be able to start the audio reproduction, at least in
the "REPEAT" line a switch must be assigned. Fol-
low the procedure described in section
Control and
switch assignment :
Touch
VOICE TRIGGER
As long as the selected switch is active, the last repro-
duced message will be repeated in the period which
has been set on the left side of the switch
TONE (module select)
If the transmitter recognizes many Vario sensors, for
example because both a General Electric and a GPS
module are installed in the model and connected to
the receiver, after tapping on the value field it is pos-
sible to select, through the
+ - or – buttons, the
desired vario announce.
Touch
Touch
The following selections are available: VARIO, GAM,
EAM, GPS so as AUTO. (In the AUTO position the
sensors order will be selected as in the aforemen-
tioned list.)
Tips
• To be able to recall also the vario tones, you need to
assign a switch in the following "VARIO" value field.
• As soon as the transmitter and/or the receiver have
been switched on, the system starts the research
of the connected sensors. A conversion in the val-
ue field
V-TON
is only possible after the 30 sec-
onds which are normally required to complete the
research. If instead of
ALWAYS you have selected
another value in the higher part of the "RX SELECT"
line …
… as for example 4x or 8x , then the process will
take longer.
TRIGGER (NEXT ANNOUNCE)
• manual
With a switch assigned to this line, preferably one
function of the two pushbuttons S2 or S8, you in-
crementally switch in a loop between the options
(described below) "TRANSMITTER", "RECEIVER",
and voice triggers selected under "Sensors". The
switch assignation is performed as described in
the "
Control and switch assignment " section:
Touch
116 Function menu - Telemetry | Voice Trigger