Fukuda Denshi DSL-8001, Руководство по эксплуатации

Страница: 13 / 252

xi
Maintenance, Modifications, and Repairs
Fukuda Denshi is liable for the safety, reliability, and performance of its
equipment only if;
 Maintenance, modifications, and repairs are carried out by authorized
personnel.
 Components are used in accordance with Fukuda Denshi operating
instructions.
A full technical description of the DSL-8001 system is available from your local
Fukuda Denshi representative.
Precautions about Medical Telemetry
DANGER
When monitoring a patient using wireless telemetry, make sure
the patient data is properly received at the central monitor. Pay
special attention when the channel ID at the bedside monitor is
changed.
WARNING
 Depending on the wireless combinations, interference may
generate with other telemeters.
 Before selecting a channel, verify it will not interfere with other
channels.
 Make sure the telemetry manager of your system is aware of
any changes to the telemetry channels.
 If transmitters are used in a neighboring medical facility, your
facility and the neighboring facility must make agreements on
the setting of the telemetry channels to prevent telemetry
interference.
CAUTION
 Precautions about the Installation
 The medical institution (hereinafter referred as
“Institution”) must decide the telemetry installation plan for
the medical institution in order to prevent interference and
interference between transmitters (telemetry based on
destination country’s radio law). When telemetry has
already been installed and been used, radio format,
frequency, and antenna power are required to be
examined to prevent interference.
 When using telemetry which requires zone location, the
Institution is to set up the zones as an operation unit for
each transmitter to prevent electronic interference
between telemetry throughout the medical institution.
 When using telemetry which requires zone location,
display and identify each prepared zone in the equipment.

When laying receiver antenna for each transmitter, the
Institution has to examine the installation so that electronic
interference does not occur.
 Based on the above examination result, the Institution
should place each receiver antenna as required.